ASHRAE 55-2007 PDF

EducationLeave a Comment on ASHRAE 55-2007 PDF

ASHRAE 55-2007 PDF

ANSI/ASHRAE Standard (Supersedes ANSI/ASHRAE Standard ) ASHRAE STANDARD Thermal Environmental Conditions. CBE Thermal Comfort tool to calculate thermal comfort according to ASHRAE Standard , ASHRAE standard 55 thermal comfort tool, thermal comfort. See Appendix I for approval dates by the ASHRAE Standards Committee, the ASHRAE an ASHRAE Standard may be purchased from the ASHRAE Web site .

Author: Kijinn Kazimuro
Country: Estonia
Language: English (Spanish)
Genre: Sex
Published (Last): 9 July 2007
Pages: 406
PDF File Size: 15.9 Mb
ePub File Size: 10.91 Mb
ISBN: 113-1-47494-614-5
Downloads: 84122
Price: Free* [*Free Regsitration Required]
Uploader: Kajikinos

This handbook chapter provides additional information for estimating and measuring activity levels. These values are valid for an average adult with surface skin area of 1.

Please verify that all attachments and references are relevant, current, and clearly labeled to avoid processing and review delays. The indicated increase in temperature pertains to both the mean radiant temperature and the air temperature. In general, body motion decreases the clothing insulation by pumping air through clothing.

Standard 55 – Thermal Environmental Conditions for Human Occupancy

I hereby attest that I have the authority ashra am empowered to grant this copyright release. For the first, it is not correct to use the average clothing insulation value to determine the desired thermal conditions for all occupants. For occupant-controlled naturally conditioned space, the adaptive model shall be used to determine the thermal comfort boundaries.

When a person is sleeping or resting in a reclining posture, the bed and bedding may provide considerable thermal insulation. However, the conditions required for thermal comfort sshrae spaces that are naturally conditioned are not necessarily the same as those conditions required for other indoor spaces. Use additional pages if needed.

Using radiant cooled floors to condition aahrae spaces and maintain comfort conditions. For VAV systems, readings shall be taken at maximum flow with minimum supply air temperature. Thermal comfort in a room heated by different methods. Compliance is achieved if the 55-2007 provide thermal neutrality, measured as falling between This area may not be considered exempt; however Airflow characteristics in the occupied zone of heated spaces without mechanical ventilation.


Clothing variability among occupants in a space is an important consideration in applying this standard. Adaptive model is a model that relates indoor design temperatures or acceptable temperature ranges to outdoor meteorological or climatological parameters.

Standard 55, Environmental Conditions for Occupancy_图文_百度文库

However, this standard allows elevated air speed to be ashraf to increase the maximum temperature for acceptability if the affected occupants are able to control ashae air speed. The effect of air speed and temperature on the thermal sensations of sedentary man. Clothing insulation is the asrhae to sensible heat transfer provided by a clothing ensemble expressed in units of clo, which is a unit to quantify the insulation provided by garments and clothing ensembles.

Standard 55 specifies conditions for acceptable thermal environments and is intended for use in design, operation, 55-20007 commissioning of buildings and other occupied spaces.

K Light Activity Standing 6. Glossary of terms for thermal physiology. The required air speed may not be higher than 0. Recommendations concerning energy source selection should be made by its members. A complete clothing ensemble may be defined using a combination of the garments listed in Table B2.

When the number is under 20, at least 16 must reply for the survey to make the survey representative. The requirements of this section are the same for drifts and ramps.

Systems designed to control humidity shall be able to maintain a humidity ratio at or below 0.


The allowable operative temperature limits in Figure 5. The role of clothing in meeting FEA energy conservation guidelines. Due to increased body coverage, the effect of increased air speed is less with higher levels of clothing insulation.

Thus, the requirements of this section may also be used for metabolic rates greater than 1. The methods are listed in order of accuracy and should be used in this order of preference. Thermal comfort during cyclical temperature fluctuations.

Humidity is a general reference to the moisture content of the air. Thermal asheae is the condition of mind that expresses satisfaction with the thermal environment and ashrrae assessed by subjective evaluation. As a result, people entering a space that meets the requirements of this standard may not immediately find the conditions comfortable if they have experienced different environmental asheae just prior to entering the space.

This asymmetry may cause local discomfort and reduce the thermal acceptability of the space. Radiant temperature asymmetry between 555-2007 and floor, and air and walls must be limited to reduce discomfort.

SinceStandard 55 has been rewritten with a renewed focus on application of the standard by practitioners and use of clear, enforceable language. The PMV method does not fully account for this factor, and this standard should not be applied to situations where the time-averaged metabolic rate is above 2.

Most office spaces fall within these limitations.