ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||24 July 2006|
|PDF File Size:||13.33 Mb|
|ePub File Size:||15.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM B162 Alloy 200 / 201 Strip Plate and Sheet Suppliers
Siddhagiri Metals and Tubes Rating: It is informational only and not an official part of the standard; the full text of the standard ashm must be referred to for its use and application. This abstract is a brief summary of the referenced standard.
The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
Historical Version s – view previous versions of standard. For deep drawing and spinning quality sheet and strip, the material asgm conform to specified values for grain size and hardness properties. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
These sheets are made by rolling process. The material shall be ast in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections.
Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part. Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and asfm conditions, without altering the sheet thickness. Also Each flat rolled product owes its final asgm not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the h162 of the anneal that follows hot rolling.
Link to Active This link will always route to the current Active version of the standard.
Siddhagiri Metals and Tubes Manufacturer: Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Looking for some more information?
Nickel 200® & Nickel 201®
Offer on Fasteners Sitemap. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein. Sheet and Strip can be cold rolled to higher strength. AlloyAlloy Brand: