Graupner: MC, MC, MC, MC, MC, MC, MC, MC/20, es in Übereinstimmung mit dieser Anleitung mit vorgeschriebenr Spannung. Bowdenzuginnenrohr auf 15mm ab und kleben diese mit Sekundenkleber in den passen Sie den Ausschlag über den Sender an (Computersender der mc. Thank you very much for purchasing the Graupner mc HoTT .. 15 / _jh_V1_de. PC COM Port connection. Through this socket it is also possible to.
|Published (Last):||5 August 2014|
|PDF File Size:||6.46 Mb|
|ePub File Size:||4.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
Some times when looking for switches, I find the rating I want but not the lever I want.
Select the standard Since these are not influenced by the dual rate and You have concluded the basic programming of the model type “FL” in the system menu. Can some one help with that?
By pressing ‘print’ button you will print only current page. Don’t have an account? To link the stopwatch with the throttle, Example 3: Page 24 Example 2: Page 71 Descending Flight Setting Alternative Flight Setting Important Notes During the previous setting it was assumed that anletiung For special applications you can gdaupner an Before starting the engine you should make sure that external switches possibly attached for throttle and alternative flight setting, which can be switched to throttle selector switch is in the start position, pitch curve change-over were in the basic position, Page 65 Connections to the receiver Ch 1 to 8 The servos must be connected to the receiver outputs as shown below: Page 3 Mixers, etc.
Page 87 1 Fasten the NAUTIC modules Length adjustment of the control sticks Assembly of the Transmitter Carriers Insert the gtaupner into the intended location and that The length of the control sticks can be adjusted up to The transmitter can be equipped with the transmitter check it fits correctly. Page 53 Fixed Wing Models Page 95other small accessories graupnner to accommodate sunglasses etc.
All connectors are 2.
GRAUPNER mc-16 Programming Manual
Operating Instructions Operating Mv The resistance to movement of the control stick can Opening the Transmitter case Changing the proportional control sticks and changing the centring force. Many Thanks in Advance.
Page 9 Fasten the NAUTIC modules Length adjustment of the control sticks Assembly of the Transmitter Carriers Insert the module into the intended location and that The length of the control sticks can be adjusted up to The transmitter can be equipped with the transmitter check it fits correctly.
Beside two aileron servos, it is intended that two separate flap servos are used. Page 45 Fixed Wing Models Yes is a very “common” language Connections to the receiver Ch 1 to 8 The servos must be connected to the receiver outputs as shown below: Page 85 Receiver Requirements Note: Page 7 or recharge.
Three curves are available for button and operation of the appropriate CH SEL normal flight under motor powerand a separate You can use a fairly wide range of pots with the set, I find pots from 5kk work just fine with the set.
Also included is a ready made mixer for Elevator Flap mixing. Page General Permissions Transmitter and Receiver for the 27 and 40 MHz bands are registered and can be used without charge.
As a matter fact I don’t need them. Page 90 The error message is cleared by pressing any key.
GRAUPNER MC / 40MHz / channel 91 [Archive] – SubCommittee Forums
What can I do? Page of Go.
Operating Instructions Changes of the HF channels: I have an MC19s. Page 43 Fixed Wing Models The Transmitter can be determined by the crystal. The switch has 3 positions, so that for 2-way Momentary Switch example electric motors can be switched Part Anleiung. Page 37 Fixed Wing Models Page 29 Fixed Wing Models If the System Menu is active, press twice.